How To Install Fahrenheat Electric Baseboard Heater
Fahrenheat Electric Baseboard Heater Installation
Fahrenheat baseboard heaters are manufactured by Marley Engineered Products of Bennettsville, SC. The manufacturer offers a line of 12 electric baseboard heaters, which are designed for easy installation. They come up in lengths ranging from less than 3 feet to eight feet, and they can weigh from about half dozen pounds to xviii pounds. All Fahrenheat electric baseboard heaters are installed the same mode.
Keep your baseboard heater away from drapes and other objects.
Step one
Decide where the heater will be installed. Notice the ability source in the fuse box for the location where the heater will exist installed, and turn it off.
Step 2
Drill a hole in the wall, using a half-inch drill fleck, at the location where the electric supply for the heater will be. Because you're installing a baseboard heater, the pigsty will be near the floor. The heater installation will crave at least 10 inches of supply wiring.
Step 3
Mark the wall at each cease and the pinnacle of the heater with a pencil to note where the heater volition go. Using a pencil, marker two wall studs to a higher place the heater. The studs should be close to the ends of the heater, as the unit will be attached to them. Move the heater away from the wall.
Step 4
Lay the heater face-down on the floor. Using a flat-head screwdriver, remove the screws on the back of the heater to gain access to the wiring compartment.
Step 5
Loosen the screw on the cable clamp at the bottom of the heater, using a flat-caput screwdriver. Don't remove the screw. Insert the grounding cablevision into the slotted area of the wiring compartment. Pull half-dozen inches of grounding cablevision through the slotted area.
Pace 6
Replace the wiring compartment cover by securing the four screws with a flat-head screwdriver. Stand the heater upright, and place it confronting the wall at the desired location.
Footstep vii
Remove the heater's cover to expose the heating element. At the same fourth dimension, find the places near each end of the heater where the wall studs are located. Adhere the heater to the wall at these points, using forest screws. Units that are longer may crave an additional screw in the center. Tighten the screws and then loosen them a quarter plow to allow the heater to expand and contract during use. Supercede the cover.
Step 8
Remove the screw on the bottom front panel of the wiring compartment, using a apartment-head screwdriver. Connect the grounding cablevision to the copper pigtail wire nether the loosened cablevision clamp. Screw in the cablevision clamp connecting the wires, using a apartment-caput screwdriver, until the wires are secured under the cablevision clamp. Supervene upon the front panel of the wiring compartment, using a flat-head screwdriver. At this point y'all can restore the power.
Source: https://homesteady.com/how-12216390-fahrenheat-electric-baseboard-heater-installation.html
Posted by: kellyjonan2002.blogspot.com
0 Response to "How To Install Fahrenheat Electric Baseboard Heater"
Post a Comment